WeCreat Laser Settings Reference: Power, Speed & Passes by Machine
Looking for a quick WeCreat laser settings reference? The table below lists starting-point power, speed, and passes for cut, line, and engrave operations across WeCreat machines, including the Vision, Vision Pro, Vista, and Lumos. These same values feed the per-operation settings when you convert an SVG or vector design into a MakeIt! .wws file right here on wwsgen.
Use them to get the power and speed for your machine and material in the right ballpark, then fine-tune from there.
Machine defaults
These are starting points only — not guaranteed settings. Every material, brand, thickness, and even individual machine and laser tube behaves differently, so no single chart can be correct for your exact job.
- Always run a test cut or scrap-piece pass before committing to your real material.
- Dial power, speed, and passes in on your machine until you get a clean result.
- wwsgen is an unofficial, reverse-engineered tool and is not affiliated with or endorsed by WeCreat. After exporting, open the file in MakeIt! and double-check dimensions before cutting.
Community settings
Real recipes shared by makers for specific materials & thicknesses — always verify on your own machine before cutting.